Nondestructive Examination

148 Items

Under this category it is possible to find the papers focused on Nondestructive Examination

All Items

Experimental characterization of fiber-reinforced cementitious mortar under tension

Patrizia Bernardi, Roberto Cerioni, Daniele Ferretti, Filippo Leurini, Elena Michelini

Requires Subscription PDF Requires Subscription Visual Abstract
97-104
Analysis of dissipated energy and temperature fields at severe notches of AISI 304L stainless steel specimens

Daniele Rigon, Mauro Ricotta, Giovanni Meneghetti

Requires Subscription PDF Requires Subscription Visual Abstract
334-347
Mechanical and fracture properties of particleboard

Liviu Marsavina, Ion Octavian POP, Emanoil LINUL

Requires Subscription PDF Requires Subscription Visual Abstract
266-276
Development of a piezoelectric energy-harvesting sensor: from concept to reality

Konstantinos Gkoumas, Franco Bontempi, Prof.

Requires Subscription PDF Requires Subscription Visual Abstract
150-160
Deformation and failure of carbon fiber composite specimens with embedded defects during tension-torsion test

Tatyana Viсtorovna Tretyakova, Valery E. Wildemann, Elena M. Strungar, Mikhail P. Tretyakov

Requires Subscription PDF Requires Subscription Visual Abstract
295-305
Experimental study on concrete damage location by Computerized tomography and Acoustic Emission technology

Jinghong Liu, Jian Xie, Yongjian Liu, Panfei Shi

Requires Subscription PDF Requires Subscription Visual Abstract
352-360
Numerical simulation of a heat generation in a layered material during ultrasonic wave propagation

Anastasiia Kostina, Oleg Plekhov, Sergey Aizikovich

Requires Subscription PDF Requires Subscription Visual Abstract
332-342
Investigation of the effect of cracks on the vibration processes in reinforced concrete structures

Igor Shardakov, Aleksey Shestakov, Roman Tsvetkov, Irina Glot

Requires Subscription PDF Requires Subscription Visual Abstract
383-390
Considerations over the Italian road bridge infrastructure safety after the Polcevera viaduct collapse: past errors and future perspectives

Fabio Bazzucchi, Luciana Restuccia, Giuseppe Ferro

Requires Subscription PDF Requires Subscription Visual Abstract
400-421
Management of multi-source information to identify the typology of the horizontal structures in historical masonry buildings: the case study of the Museum of Capodimonte in Naples (Italy)

Alessandra Maione, Luca Umberto Argiento, Claudia Casapulla, Andrea Prota

Requires Subscription PDF Requires Subscription Visual Abstract
240-251
Pre-failure indicators detected by Acoustic Emission: Alfas stone, cement-mortar and cement-paste specimens under 3-point bending

Stavros K. Kourkoulis, Ioanna Dakanali

Requires Subscription PDF
Pages 74-84
Eddy current modelling using multi-layer perceptron neural networks for detecting surface cracks

Salaheddine Harzallah, R. Rebhi, M. Chabaat, A. Rabehi

Requires Subscription PDF Requires Subscription Visual Abstract
147-155
The effect of porosity on fragmentation statistics of dynamically loaded ZrO2 ceramics

Marina Davydova, Sergei Uvarov, Oleg Naimark

Requires Subscription PDF
Pages 106-112
Regularities of mechanical behavior of steel 40Cr during the postcritical deformation of specimens in condition of necking effect at tension

M.P. Tretyakov, T.V. Tretyakova, V.E. Wildemann

Requires Subscription PDF
Pages 146-154
A numerical and experimental study through laser thermography for defect detection on metal additive manufactured parts

N. Montinaro, D. Cerniglia, G. Pitarresi

Requires Subscription PDF
Pages 231-240
Pilot evaluation of a fracture process zone in a modified compact tension specimen by X-ray tomography

Jiri Klon, Stanislav Seitl, Hana Simonova, Zbynek Kersner, Ivana Kumpova, Daniel Vavrik

Requires Subscription PDF
Pages 161-169
Influence the loading conditions and the stress concentrators on the spatial-time inhomogeneity due to the yield delay and the jerky flow: study by using the digital image correlation and the infrared analysis

Tatyana V. Tretyakova, Valery E. Wildemann

Requires Subscription PDF
Pages 303-314
Failure analysis of thin metal foils

G. Bolzon, M. Shahmardani, R. Liu, E. Zappa

Requires Subscription PDF
Pages 328-336
Experimental methodology for the quantification of crack tip plastic zone and shape from the analysis of displacement fields

J.M. Vasco-Olmo, F.A. Diaz, M.N. James, C.J. Christopher, E.A. Patterson

Requires Subscription PDF
Pages 166-174
Measurement and analysis of fatigue crack deformation at the micro-scale

D. Nowell, K.I. Dragnevski, S.J. O’Connor

Requires Subscription PDF
Pages 197-202
On DIC measurements of DeltaKeff to verify if it is the FCG driving force

Julián Andrés Ortiz González, Jaime Tupiassú Pinho de Castro, Giancarlo Luis Gomez Gonzáles, Marco Antonio Meggiolaro, José Luiz de França Freire

Requires Subscription PDF
Pages 227-235
Stress Intensity Factor calculation from displacement fields

S. Beretta, L. Patriarca, S. Rabbolini

Requires Subscription PDF
Pages 269-276
Study of strain localizations in a polycrystalline medium in presence of a quasi-static crack

L. Patriarca, P.G. Luccarelli, S. Foletti

Requires Subscription PDF
Pages 277-284
Variable mode-mixity during fatigue cycles – crack tip parameters determined from displacement fields measured by digital image correlation

Michael Vormwald, Yigiter Hos, José L.F. Freire, Giancarlo L.G. Gonzáles, Jorge G. Díaz

Requires Subscription PDF
Pages 314-322
Williams expansion-based approximation of the stress field in an Al 2024 body with a crack from optical measurements

S. Seitl, L. Malíkova, J. Sobek, P. Frantík, P. Lopez-Crespo

Requires Subscription PDF
Pages 323-331
Acoustic Emissions versus Pressure Stimulated Currents during bending of restored marble epistyles: Preliminary results

Stavros K. Kourkoulis, Ioanna Dakanali, Ermioni D. Pasiou, Ilias Stavrakas, Dimos Triantis

Requires Subscription PDF
Pages 536-551
Regularities of fracture pattern formation in alumina ceramics subjected to dynamic indentation

E. Tolmacheva (Lyapunova), M. Davydova, V. Chudinov, S. Uvarov, O. Naimark, D. Zaytsev, P. Panfilov

Requires Subscription PDF
Pages 552-561
Using acoustic emissions to enhance fracture toughness calculations for CCNBD marble specimens

K. Kaklis, S. Mavrigiannakis, V. Saltas, F. Vallianatos, Z. Agioutantis

Requires Subscription PDF
Pages 1-17
Acoustic emissions and pressure stimulated currents experimental techniques used to verify Kaiser effect during compression tests of Dionysos marble

Ilias Stavrakas

Requires Subscription PDF
Pages 32-40
Correlation between the electric and acoustic signals emitted during compression of brittle materials

Ermioni D. Pasiou, Dimos Triantis

Requires Subscription PDF
Pages 41-51
Acoustic emissions and electric signal recordings, when cement mortar beams are subjected to three-point bending under various loading protocols

A. Kyriazopoulos

Requires Subscription PDF
Pages 52-60
Strain monitoring of cement-based materials with embedded polyvinyl alcohol - carbon nanotube (PVA-CNT) fibers

Zoi S. Metaxa, Wilfrid Neri, Philippe Poulin, Nikolaos D. Alexopoulos

Requires Subscription PDF
Pages 61-73
A thermography-based method for fatigue behavior evaluation of coupling beam damper

Zhe Zhang, Jinping Ou, Dongsheng Li, Shuaifang Zhang, Junling Fan

Requires Subscription PDF
Pages 149-161
Experimental analysis on physical and mechanical properties of thermal shock damage of granite

He Xiao, Li Qing, Chen Hongkai, Tang Hongmei, Wang Linfeng

Requires Subscription PDF
Pages 181-190
Fatigue assessment by energy approach during tensile tests on AISI 304 steel

A. Risitano, D. Corallo, E. Guglielmino, G. Risitano, L. Scappaticci

Requires Subscription PDF
Pages 201-215
Numerical study of eddy current by Finite Element Method for cracks detection in structures

S. Harzallah, M. Chabaat, K. Chabane

Requires Subscription PDF
Pages 282-290
Multi-purpose fatigue sensor. Part 1. Uniaxial and multiaxial fatigue

M.V. Karuskevich, S.R. Ignatovich, ?.P. Maslak, A. Menou, P.?. Maruschak, S.V. Panin, F. Berto

Requires Subscription PDF
Pages 198-204
Multi-purpose fatigue sensor. Part 2. Physical backgrounds for damages accumulation and parameters of their assessment

M.V. Karuskevich, S.R. Ignatovich, T.P. Maslak, A. Menou, P.?. Maruschak, S.V. Panin, F. Berto

Requires Subscription PDF
Pages 205-214
Averaged strain energy density-based synthesis of crack initiation life in notched steel bars under torsional fatigue

Filippo Berto, Alberto Campagnolo, Giovanni Meneghetti, Keisuke Tanaka

Requires Subscription PDF
Pages 215-223
Structural mechanisms of formation of adiabatic shear bands

Mikhail Sokovikov, Dmitry Bilalov, Vladimir Oborin, Vasiliy Chudinov, Sergey Uvarov, Yuriy Bayandin, Oleg Naimark

Requires Subscription PDF
Pages 296-304
Failure analysis of dissimilar single-lap joints

F.A. Stuparu, D.A. Apostol, D.M. Constantinescu, M. Sandu, S. Sorohan

Requires Subscription PDF
Pages 69-77
Numerical simulation of dynamic brittle fracture of pipeline steel subjected to DWTT using XFEM-based cohesive segment technique

Reza H. Talemi

Requires Subscription PDF
Pages 151-159
Acoustic emission characteristics of instability process of a rock plate under concentrated loading

S.R. Wang, C.Y. Li, Z.S. Zou, X.L. Liu

Requires Subscription PDF
Pages 182-190
Relation between the plastic instability and fracture of tensile tested Cu-Sn alloys investigated with the application of acoustic emission technique

W. Ozgowicz, B. Grzegorczyk, A. Pawelek, W. Wajda, W. Skuza, A. Piatkowski, Z. Ranachowski

Requires Subscription PDF
pages 11-20
Mechanisms of plastic instability and fracture of compressed and tensile tested Mg-Li alloys investigated using the acoustic emission method

A. Pawelek, A. Piatkowski, W. Wajda, W. Skuza, A. Tarasek, W. Ozgowicz, B Grzegorczyk, Z. Ranachowski, S. Kúdela Jr, S. Kúdela

Requires Subscription PDF
pages 21-30
New experimental techniques for fracture testing of highly deformable materials

E. Dall’Asta, V. Ghizzardi, R. Brighenti, E. Romeo, R. Roncella, A. Spagnoli

Requires Subscription PDF
pages 161-171
Fatigue properties and fracture mechanism of load carrying type fillet joints with one-sided welding

Takamasa Abe, Hiroyuki Akebono, Masahiko Kato, Atsushi Sugeta

Requires Subscription PDF
pages 196-205
Combined lock-in thermography and heat flow measurements for analysing heat dissipation during fatigue crack propagation

J. Baer, A. Vshivkov, O. Plekhov

Requires Subscription PDF
Modelling of ultrasonic impact treatment (UIT) of welded joints and its effect on fatigue strength

K.L. Yuan, Y. Sumi

Requires Subscription PDF
2D size, position and shape definition of defects by B-scan image analysis

Michele Scafidi, Donatella Cerniglia, Tommaso Ingrassia

Requires Subscription PDF

Previous 51-100 of 148 Next